System configuration Software composition > Measurement item Hardware specification

Width of line Alignment cross Alignment line Luminance Area rate The distance (space interval) of the line image continuously printed at constant intervals between the width of a center distance of the distance (address) from an arbitrary starting point to each line and the adjoining line (line pitch) and each line and the adjoining lines is measured at the same time. Alignment at the print position is measured while minute adjusting the position of view so that the print of a cross line of the CMYK4 color may become the center of the image for center coordinates (coordinates to an arbitrary starting point). The alignment of column of the CMYK4 color line is measured for center coordinates. (coordinates to arbitrary starting point) The view distribution of each view is measured while moving the stage of the patch and the gray scale of the test chart. Data measures the maximum, the minimum in each view, and the average, the peak brightness, and the brightness standard deviation by 256 step displays. The stage is moved to an arbitrary location on the sample, and the area of making to binary of each view is obtained . The print accuracy and the reproducibility of the dot are evaluated.

Particle Center of line Brightness section Resist Stage coordinates acquisition A special small amount concerning shape like the area and the surroundings length, etc. of an arbitrary part on the sample is obtained. The print accuracy and the reproducibility of the dot are evaluated. An arbitrary center of the line image to the starting point and the coordinates value of an upper and lower edge are measured . The undulation of the line and the evaluation of the ruggedness of the edge are done. Brightness profile data of the core(of absorption line) of each view is measured . It is possible to apply for evaluation to the sharpness and the concentration irregularity evaluation in the print part. Center coordinates and sample marginal four points coordinates at the intersection printed for the form of the sample are measured respectively, and the gap of the print to the form and bending are evaluated. Coordinates where the stage moves when automatic operation (Or, it is semiautomatic) in measuring are set . The coordinates value where the stage moves when measuring while confirming the reflection of the camera on the monitor is acquired.